Tools And Utilities - Oce Arizona 440 GT User Manual

User Manual: Arizona (AZ) 440 GT, AZ 440 XT, AZ 460 GT, AZ 460 XT, AZ 480 GT, AZ 480 XT - Rev. B, 4/2013
Special Prints
The Special Prints module displays two lists. The list on the left shows the
available special prints. Some of these prints are used by service
technicians to adjust and troubleshoot the printer. Some are of interest to
the Operator: the Ship print, the table ruler prints, the Nozzle Check print,
and the Media Advance Correction Factor print.
Special Prints of Interest to the Operator
• the Reference print is used to determine that the printer output meets
quality standards. A ship print that is printed at the factory is shipped
with each printer. It can be used as a comparison with one printed at the
customer site.
• The Table Rulers are meant to be printed on the table to assist you to
place media. These images are set up to print on the horizontal and
vertical axes of the table. They are available in metric or imperial
measure.
• The Nozzle Check is used to determine if there are any clogged nozzles
that can affect print quality (note that it is also available on the
command toolbar in the Print Job Control module).
• the Media Advance Correction Factor print (used for roll media only).
This print is used to correct a certain type of banding related to incorrect
media advance - see How to Determine Media Advance Correction.
The list on the right shows all active jobs that are currently in the print
queue. Add a special print from the left into the right list to make it active
in the Print Job Control module. If you remove a job from this list, it is also
removed from the Active job list and is not available to print. Special print
instances that are removed from the Active list do not go to the Inactive
list; they are simply removed.
Chapter 4 - How to Navigate the User Interface
Tools and Utilities Module
69