How To Use Media Edge - Oce Arizona 440 GT User Manual

User Manual: Arizona (AZ) 440 GT, AZ 440 XT, AZ 460 GT, AZ 460 XT, AZ 480 GT, AZ 480 XT - Rev. B, 4/2013
How to Use Media Edge Protectors
[77] Side View of Media Protector
3.
Bend the height adjustor (small triangle in the top corner of the edge
protector) slightly and then straighten it again. This results in a slight bend
(no more than a media thickness), that allows the media edge to move
more freely under the protector.
[78] Media Edge Detector Height Adjustor
IMPORTANT
If the height adjustor area is higher than 1 mm from the platen, there is a
possibility that the carriage may hit the edge of the protector and thus
damage printhead nozzles.
4.
Peel the backing layer from the double-sided tape on the back of the
protector.
5.
Place the bent edge of the protector into the media cut guide, but do not
press down on the tape yet.
6. Slide the protector towards the media edge until the inside edge of the
height adjustor is positioned over the media edge (see figure below).
142 Chapter 7 - How to Operate the Roll Media Option