How To Load Media - Oce Arizona 440 GT User Manual

User Manual: Arizona (AZ) 440 GT, AZ 440 XT, AZ 460 GT, AZ 460 XT, AZ 480 GT, AZ 480 XT - Rev. B, 4/2013
[63] Ruler to Center Media
NOTE
The supplied ruler has both metric (millimeters) and imperial (inches)
scales. When a media roll is centered on the shaft, and the ruler is placed
as shown in the photo, the value on the ruler scale will match the width of
the roll. For example, in the photo a 2 meter (or 2000mm) roll is centered
on the media shaft.
6.
Lock the supply media shaft core locks by turning the 5mm hex key clock-
wise.
7. Re-check that the media is still centered as locking the core may cause the
roll to shift (usually the shift is from 1 to 2 millimeters to the right).
Next: Load an Empty Core and Install it in the Take-up Position
8.
Place an empty media shaft on a suitable work surface and unlock the
media shaft locks with the 5mm hex key.
9.
Slide an empty media core that is at least as long as the supply media
width onto the take-up shaft.
10. Roughly center the core and then insert the shaft into the Take-up (top)
position on the RMO unit.
NOTE
Make sure that the core lock and coupler end of the shaft are on the right
side of the printer.
11.
Lock the take-up media shaft core locks with the 5mm hex key.
Chapter 7 - How to Operate the Roll Media Option

How to Load Media

125