Oce Arizona 440 GT User Manual page 79

User Manual: Arizona (AZ) 440 GT, AZ 440 XT, AZ 460 GT, AZ 460 XT, AZ 480 GT, AZ 480 XT - Rev. B, 4/2013
IMPORTANT
To maintain optimal printer reliability, leave the power on at all times.
However, there are exceptions such as for ink flushes, some service
procedures, or if the printer requires a reboot. If you need to shut down
the printer for just a few minutes, follow this procedure. However, if you
need to leave the printer idle for periods of 30 minutes to 14 days, see the
table below.
Procedure
1.
Turn off the UV lamps.
2.
Wait for the lamps to cool down (fans will stop).
3.
Click on the Shutdown icon in the Tools and Utilities tab to exit the printer
software.
4.
Turn the AC power switch to the OFF position.
5.
Turn the power back on when the service or procedure is complete.
NOTE
Avoid Extended Power Off
If the power is switched off for only a short period (for example, when the
printer is shut down and then immediately restarted to correct an
electrical problem or other troubleshooting), no special action is required
at startup. However, if it is necessary to leave the printer idle for an
extended period refer to the table below. Also, perform Printhead
Maintenance and Swab the printheads when you start to use it again. We
recommend that you leave the printer powered On at all times except for
maintenance or repair.
Chapter 5 - How to Operate Your Océ Arizona Printer
How to Power Off
79