Configure Onyx Software For White Ink / Varnish; Procedure - Oce Arizona 440 GT User Manual

User Manual: Arizona (AZ) 440 GT, AZ 440 XT, AZ 460 GT, AZ 460 XT, AZ 480 GT, AZ 480 XT - Rev. B, 4/2013

Configure ONYX Software for White Ink / Varnish

Configure ONYX Software for White Ink /
Varnish
Introduction
This section describes how to configure ONYX software (either THRIVE or
ProductionHouse) to recognize white ink or varnish workflow elements and
thus allow you to apply the approach that is best for your print job
application. In order for the ONYX software to successfully address white
ink or varnish workflow data, there are options in the software that must
be configured. It also explains how you need to use specific ONYX media
profiles to prepare white ink and varnish print jobs.
NOTE
Step 1 and 2 below are required for ProductionHouse only. Step 3 is
needed for both ProductionHouse and THRIVE.

Procedure

1. Within Rip-Queue, access the Configure Rip Options Palette.
[84] Set up ONYX RIP
2.
Once here, ensure that Overprint is turned on (checked).
160 Chapter 9 - How to Work With White Ink and Varnish