Settings Module - Oce Arizona 440 GT User Manual

User Manual: Arizona (AZ) 440 GT, AZ 440 XT, AZ 460 GT, AZ 460 XT, AZ 480 GT, AZ 480 XT - Rev. B, 4/2013

Settings Module

Allows you to set the following:
• Flatbed print gap
• Underlay thickness
• Table vacuum timeout
• End of swath delay
• Full carriage travel
• Automatic warmup day
• Automatic warmup time
• Ionizer bar (static suppression - On or Off)
Roll Module
[42] Roll Media Settings
Top Margin
Specifies the distance left unprinted above the image.
Bottom Margin
Specifies the distance left unprinted below the image.
Media Move on Unload
Specifies the amount of media moved on unload in the selected
measurement units.
NOTE
This setting icon is displayed only if the Roll Media Option is installed.
66 Chapter 4 - How to Navigate the User Interface