Chapter 4 - Oce Arizona 440 GT User Manual

User Manual: Arizona (AZ) 440 GT, AZ 440 XT, AZ 460 GT, AZ 460 XT, AZ 480 GT, AZ 480 XT - Rev. B, 4/2013
Flatbed Set‐
tings
Roll enable
Roll Media
Manager
A dialog window automatically appears when confirma-
tion is required. If it is closed before you select Confirm,
it can be reopened by clicking on this button.
Media Parameters
Enter or confirm the thickness of the media. The printer
will automatically adjust the carriage height to media
thickness and also the print gap. Media thickness confir-
mation is required only for the first copy of a print job,
unless it is changed during printing. If the media thick-
ness value is changed while printing, confirmation is re-
quested before printing the next copy.
Lamp Power Control
Allows the operator to control the power output of each
UV lamp independently. To extend lamp life, use the low-
est setting that provides adequate curing for a particular
media.
Leading and Trailing Edge are relative to the direction of
carriage travel. To enable or disable this setting, see the
User Interface section of the Settings page "Tie lamp con-
trols together". When enabled, this feature automatically
matches the power of the trailing UV lamp, when power
of the leading UV lamp changes. It is still possible to ad-
just the power of the trailing UV lamp individually, when
this setting is not enabled.
Click on the Roll icon to enable or disable the Roll Media
Option print queue (this allows you check media parame-
ters before the job actually prints). Roll media print jobs
will not print unless this icon is selected.
NOTE
Roll media print jobs do not require explicit
user actions to start the print job once Roll
module is initialized (see Roll Media Manager
in the RMO) If this icon is selected, and the job
status is not on Hold, roll media print jobs will
start automatically when the printer receives
the job.
The Roll Media Manager allows the operator to load and
unload media and to initialize the Roll module so that the
tension on the roll media is set and the job is ready to
print.
Chapter 4 - How to Navigate the User Interface
Print Job Control Module
51
4