Driven Face Bearing Installation - Honda 2003 NPS50 Ruckus Service Manual

KICKSTARTER/DRIVE PULLEY /DRIVEN PULLEY /CLUTCH
Set the clutch spring compressor over the clutch/
To prevent loss of
driven pulley assembly and compress the driven
tension, do not
face spring.
compress the
clutch spring more
TOOL:
than necessary to
Clutch spring compressor
install the stopper
ring.
Align the spline of the driven face with the spline of
Be careful not to
the drive plate while compressing the clutch spring
damage the spline.
compressor.
Install the stopper ring securely.
Remove the clutch/driven pulley assembly from the
spring compressor.
INSTALLATION
Rotate the movable driven face clockwise and install
the drive belt into the driven pulley.
Do not get any oil and grease on the driven face
inside.
Install the clutch/driven pulley assembly onto the
d rives haft.
Clean any oil and grease from the inside of the
clutch outer.
Install the clutch outer and clutch outer nut.
Hold the clutch outer with the special tool and
tighten the clutch outer nut to the specified torque.
TOOL:
Universal holder
TORQUE: 39 N·m (4.0 kgf·m, 29 lbf . ft)
Install the drive pulley (page 1 0-1 1 ).
1 0- 1 8
07LME-GZ40200 or
07960-KM1000A
(U.S.A. only)
07725-0030000