Front Wheel Installation - Honda 2003 NPS50 Ruckus Service Manual

FRONT WHEEl/BRAKE/SUSPENSION/STEERING
INSTAllATION
Install the brake panel aligning the tabs of the
speedometer gear with the grooves of the wheel
hub.
Install the front wheel between the fork legs align-
ing the brake panel g roove with the left fork leg tab.
Install the collar and front axle from the left side.
Install the axle nut and tighten it to the specified
torque.
TORQUE:
Coat a new 0-ring with oil and install it on the
speedometer cable.
Connect the speedometer C able into the brake panel
by aligning the tab of the speedometer cable with
the hole of the brake panel.
Route the cable Install the joint pin into the brake arm.
properly. Connect the brake cable through the cable holder to
the joint pin and install the adjusting nut.
Adjust the front brake lever free play (page 4-16).
1 4- 1 0
44
N·m (4.5 l<gf·m, 33 lbf·ft)
BRAKE PANEL