Movable Drive Face - Honda 2003 NPS50 Ruckus Service Manual

KICKSTARTER/DRIVE PULLEY /DRIVEN PULLEY /CLUTCH

MOVABLE DRIVE FACE

Check the d rive face boss far wear or damage.
Measure the boss O.D.
SERVICE LIMIT: 19.97 mm (0.786 in)
Measure the face bushing I. D.
SERVICE LIMIT: 20.13 mm (0.793 in)
ASSEMBLY
Clean any oil and grease from the pulley faces and
weight rollers.
Install the weight rollers on the movable drive face.
Install the ramp plate.
INSTALLATION
Clean any oil and grease from the pulley faces and
the drive belt.
Install the drive face bass into the movable drive
face assembly.
Install the movable drive face assembly onto the
crankshaft while holding the ramp plate.
Install the drive belt onto the drive face boss.
Install the drive pulley face, ratchet plate and P""!"'" ""'" ".'!,. ." "'" "!"'"!"' "F ��'!'"'! '=;: :�"T72�? :: :: :=:" "1 11 11 11
washer.
Apply oil to the drive pulley face nut threads and
seating surface, then install the nut.
Hold the drive pulley face with the special tool and
tighten the nut to the specified torque.
TOOL:
Universal holder
TORQUE: 32 N-m (3.3 l<gf·m, 24 lbf·ft)
Install the belt case cover (page 1 0-6).
WEIGHT ROLLER
07725-0030000
RAMP PLATE
1 0- 1 1