Honda 2003 NPS50 Ruckus Service Manual page 91

After '05 model: Connect the throttle cable to the throttle drum and
i nstall it to the cable holder.
Loosely tighten the throttle cable adjusting nut.
Connect the throttle position sensor 3P connector
and starting enrichment (SE) valve 2P connector.
Connect the fuel hose, vacuum piston hose and
water hose to the carburetor.
Remove the hose clamp.
Install the wire harness clamp to the stay.
After installing the carburetor, check for the follow­
ing:
- Coolant level (page 4-13)
- Engine idle speed (page 4-12)
- Throttle grip free play (page 4-4)
If the throttle position sensor is removed, be sure to
reset the data (page 17-10).
Install the floor step (page 3-7).
THROTTLE CABLE
FUEL HOSE
FUEL SYSTEM
2P CONNECTOR
WATER HOSE
6- 1 7