Front Wheel Disassembly; Wheel Bearing - Honda 2003 NPS50 Ruckus Service Manual

FRONT WHEEL/BRAKE/SUSPENSION/STEERING
WHEEL
Check the rim runout by placing the wheel in a turn- ,--- -- -- -- -- -- -- -- -- -,
ing stand.
Spin the wheel slowly and read the runout using a
dial i ndicator.
Actual runout is 1/2 the total indicator reading.
SERVICE LIMITS:
Radial: 2.0 mm (0.08 in)
Axial:

WHEEL BEARING

Turn the inner race of each bearing with your finger. ,--- -- -- -- -- -- -- -- -- -,
The bearings should turn smoothly and quietly.
Also check that the bearing outer race fits tightly in
the hub.
Replace the wheel Remove and discard the bearings if the races do not
bearings in pairs. turn smoothly, quietly, o r if they fit loosely in the
hub.
DISASSEMBLY
Remove the dust seal.
Replace the wheel Install the bearing remover head into the bearing.
bearings in pairs. From the opposite side of the wheel, install the
Do not reuse old bearing remover shaft and drive the bearing out of
bearings. the whee[ hub.
Remove the distance collar and drive out the other
bearing.
TOOLS:
Bearing remover shaft
Bearing remover head, 10 mm
1 4-8
2.0 mm (0.08 in)
07746-0050100
07746-0050200
WHEEL BEARING