Honda 2003 NPS50 Ruckus Service Manual page 210

FRONT WHEEL/BRAKE/SUSPENSION/STEERING
Install the brake arm by aligning the punch marks
on the brake arm and brake cam.
Install the brake arm pinch bolt and nut as shown
and tighten the nut to the specified torque.
TORQUE: 5.4 N·m (0.55 kgf·m, 4.0 lbf . ft)
Apply grease to the speedometer gear and pinion
gear sliding surface.
Install the speedometer gear.
Apply grease to a new dust seal lip and install it into
the brake panel.
Apply grease to the anchor pin and brake cam slid­
ing surfaces.
Install the brake shoes and springs onto the brake
If the brake shoes
panel as shown.
and springs are
Wipe any excess grease off the brake cam and
reused, they must
anchor pin.
be placed back in
their original loca-
INSTALLATION
tions.
Install the front wheel (page 14-10).
1 4- 1 4
BRAKE ARM
Align
SHOE SPRINGS
BOLT
BRAKE SHOES