Brake/Tail Light Bulb Replacement; Brake/Tail Light Inspection - Honda 2003 NPS50 Ruckus Service Manual

LIGHTS/METERS/SWITCHES
BRAKE/TAIL LIGHT
BULB REPLACEMENT
Remove the screws and brake/tail light lens.
While pushing the bulb in, turn it counterclockwise
to remove it, and replace it with a new one.
Make sure that the rubber seal is installed in posi­
tion and is in good condition. Replace it with a new
one if necessary.
Install the brake/tail light lens and tighten the
NOTE:
screws.
•
INSPECTION
Normally, the tail light will come on when the
ignition switch is turned to O N even when the
engine is not started, with the brake light ready
for operation. The lights will not work when the
battery voltage falls below the prescribed limit,
but will go on or be ready for operation after
starting the engine.
Brake/tail light does not operate
1 . Operation of The Lights Inspection
Check if the tail light and bral<e light do not oper­
ate.
Which light does not operate?
Tail Light-
Brake light- GO TO STEP 2.
Both tail light and brake light-
2. Brake Light Switch Inspection
Turn the ignition switch to ON.
Squeeze the front or rear brake lever and check
the operation of the brake light.
Do either brake light not operate even
brake lever is squeezed?
NO
YES
1 9-8
•
•
•
Open circuit in the Black/brown wire
•
between the sub fuse and tail light
connectors.
Faulty main relay.
Blown sub fuse ( 1 0A).
•
Faulty ECM.
•
Open circuit i n the Green/black wire
between the load cut relay and
brake/tail light connectors.
• Check load cut relay (page 1 9-23)
Faulty ECM.
- Inspect the brake light switch (page 19-
22).
GO TO STEP 3.
-
RUBBER SEAL
LENS
SCREWS
if
its
BULB