Engine Oil Strainer Screen; Engine Idle Speed - Honda 2003 NPS50 Ruckus Service Manual

MAINTENANCE

ENGINE OIL STRAINER SCREEN

Drain the engine oil (page 4-1 1 ) .
Remove t h e o i l strainer cap a n d 0-ring.
Remove the spring and oil strainer screen.
Clean the oil strainer screen.
Coat a new D-ring with oil.
Install the oil strainer screen and spring i nto the
crankcase as shown.
Install and tighten the oil strainer cap with a new 0-
ring.
TORQUE: 20 N·m (2.0 kgf·m, 14 lbf . ft)
Fill the crankcase with the recommended engine oil
(page 4-10).
NOTE:
•

ENGINE IDLE SPEED

•
Inspect and adjust the idle speed after all other
engine maintenance items have been performed
and are within specifications.
The engine must be warm for accurate idle speed
inspection and adjustment.
Warm up the engine to normal operating tempera­
ture.
Support the scooter with its center stand on a level
surface.
Remove the plug maintenance lid and connect a
tachometer.
Check the idle speed and adjust it by turning the
throttle stop screw as required.
IDLE SPEED: 2,000 ± 100 rpm
4- 1 2