Table of Contents
Advertisement
M
L
ULTIFUNCTION
EVER
The multifunction lever is located on the left side of
the steering column.
Multifunction Lever
D
R
L
AYTIME
UNNING
IGHTS
The Daytime Running Lights (DRLs) (low intensity)
come on whenever the engine is running, and the
transmission is not in the PARK position. The lights
will remain on until the ignition is placed in the OFF
or ACC position, or the parking brake is engaged.
NOTE:
For vehicles sold in Canada, the Daytime
Running Lights will automatically deactivate
when the front fog lights are turned on.
On some vehicles, the Daytime Running Lights
may deactivate or reduce intensity on one side
of the vehicle (when a turn signal is activated on
that side), or on both sides of the vehicle (when
the hazard warning lights are activated).
Where allowed by law, the DRLs function may be
disabled through the Uconnect system
Ú page 152.
H
/L
IGH
OW
Push the multifunction lever toward the instrument
panel to switch the headlights to high beams.
Pulling the multifunction lever back will turn the
low beams on.
A
UTOMATIC
The Automatic High Beam Headlamp Control
system provides increased forward lighting at night
(DRL
)
S
by automatically controlling the high beams
through the use of a camera mounted on the
inside rearview mirror. This camera detects vehicle
specific light and automatically switches from high
beams to low beams until the approaching vehicle
is out of view.
NOTE:
The Automatic High Beam Headlamp Control
can be turned on or off by selecting "ON" under
"Auto Dim High Beams" within your Uconnect
Settings Ú page 152, as well as turning the
headlight switch to the AUTO position.
B
S
EAM
WITCH
H
B
— I
E
IGH
EAM
F
QUIPPED
GETTING TO KNOW YOUR VEHICLE
Broken, muddy, or obstructed headlights and
taillights of vehicles in the field of view will
cause headlights to remain on longer (closer to
the vehicle). Also, dirt, film, and other obstruc-
tions on the windshield or camera lens will
cause the system to function improperly.
If the windshield or Automatic High Beam Head-
lamp Control mirror is replaced, the mirror must
be re-aimed to ensure proper performance. See
a local authorized dealer.
To opt out of the Advanced Auto High-Beam
Sensitivity Control (default) and enter Reduced
High-Beam Sensitivity Control (not recom-
mended), toggle the high beam lever six full on/
off cycles within 10 seconds of ignition ON. The
system will return to the default setting upon
ignition off.
F
-T
-P
LASH
O
ASS
You can signal another vehicle with your headlights
by lightly pulling the multifunction lever toward you.
This will cause the high beam headlights to turn on,
and remain on, until the lever is released.
45
2
Advertisement
Table of Contents
