Using Secure Mode - Lexmark X940E User Manual

Administrative support
6
Type the same password in each Password box.
Changing this setting will cause the print server to reset.
7
Click Submit.

Using Secure mode

Secure mode is a way to securely communicate over Transmission Control Protocol (TCP) and User Datagram Protocol
(UDP) ports.
Note: An administrative password for the Embedded Web Server must be created before Secure mode can be
enabled.
To configure Secure mode using the Embedded Web Server:
1
Open a Web browser.
2
In the address bar, type the network printer or print server IP address, and then press Enter.
3
Click Configuration.
4
Under Other Settings, click Security.
5
Click TCP/IP Port Access.
6
Select the Secure Mode Active check box.
Note: If Secure Mode Active is gray or not selectable, create an administrative password and try again.
7
Select a setting for each listed port, and then click Submit.
There are three ways to configure the TCP and UDP network ports:
•
Disabled—Port is disabled and never allows network connections
•
Secure and Unsecure—Port is always open including when the printer is in Secure mode
•
Unsecured Only—Port is open only when printer is in Secure mode
236