Remove Paper From All Bins; Remove Paper From Standard Bin; Replace All Originals If Restarting Job; Resetting The Printer - Lexmark X940E User Manual

Understanding printer messages
Remote Management Active DO NOT POWER OFF
The printer settings are being configured. Wait for the message to clear.
Warning—Potential Damage: Do not turn the printer power off while Remote Management Active appears
on the display.

Remove paper from all bins

Output bins have reached their capacity. Remove paper from all output bins to clear the message and continue printing.

Remove paper from standard bin

The standard exit bin has reached its capacity. Remove paper from the standard exit bin to clear the message and
continue printing.
Remove paper from bin <x>
The specified output bin has reached its capacity. Remove paper from the specified bin to clear the message and
continue printing.

Replace all originals if restarting job.

One or more messages which interrupted a scan job are now cleared. Replace the original documents in the scanner
to restart the scan job.
•
Touch Cancel Job if a scan job is processing when the message appears. This cancels the job and clears the message.
•
Touch Scan from Automatic Document Feeder if the page jam recovery is active. Scanning resumes from the ADF
immediately after the last successfully scanned page.
•
Touch Scan from flatbed if page jam recovery is active. Scanning resumes from the scanner glass (flatbed)
immediately after the last successfully scanned page.
• Touch Finish job without further scanning if page jam recovery is active. The job ends at the last successfully scanned
page, but the job is not canceled. Successfully scanned pages go to their destination: copy, fax, e-mail, or FTP.
•
Touch Restart job if job recovery is active and the job is restartable. The message clears. A new scan job containing
the same parameters as the previous job starts.

Resetting the printer

Wait for the message to clear.

Restore Held Jobs?

•
Touch Continue to restore all held jobs stored on the printer hard disk.
• Touch Do not restore if you do not want any print jobs to be restored.

Restoring Factory Defaults

Wait for the message to clear.
198