Lexmark X940E User Manual page 140

Understanding printer menus
Menu item
Allow Background Removal
On
Off
Allow Custom Job Scans
On
Off
Scanner Jam Recovery
Job level
Page level
Web Page Refresh Rate
30–300
Contact Name
<none>
Location
<none>
Alarms
Alarm Control
Toner Alarm
Staple Alarm
Hole Punch Alarm
Timeouts
Standby Mode
Disabled
2–240
Description
Specifies whether image background removal is allowed during
copy, fax, e‑mail, FTP, or scan to USB
Note: On is the factory default setting. The background of the
image will be removed.
Lets you scan multiple jobs to one file
Note: On is the factory default setting. If On is selected, the Allow
Custom Job Scans setting can be enabled for specific jobs.
Specifies how a scanned job should be reloaded if a paper jam
occurs in the ADF
Notes:
•
If Job level is selected, the entire job must be rescanned if
any pages jam.
•
If Page level is selected, rescan from the jammed page
forward.
Specifies the number of seconds between embedded Web page
refreshes
Note: 120 seconds is the factory default setting.
Specifies a contact name for the printer
Note: The contact name will be stored on the embedded Web
page.
Specifies the location of the printer
Note: The contact name will be stored on the embedded Web
page.
Sets an alarm to sound when the printer requires operator
intervention
Available selections for each alarm type are:
Off
Single
Continuous
Notes:
•
Single is the factory default setting for Alarm Control. Single
sounds three quick beeps.
•
Off is the factory default setting for Toner Alarm, Staple
Alarm, and Hole Punch Alarm. Off means no alarm will
sound.
• Continuous repeats three beeps every 10 seconds.
•
Stapler Alarm and Hole Punch Alarm are available only when
the finisher is installed.
Specifies the number of minutes of inactivity before the system
enters a lower power state
Note: 15 minutes is the factory default setting.
140