Supporting Ipsec; Supporting Snmpv3 - Lexmark X940E User Manual

Administrative support
To modify the confidential print settings:
1
Open a Web browser. In the address bar, type the IP address of the printer or print server to be protected using
the format: http://ip_address/.
2
Click Configuration.
3
Under Other Settings, click Security.
4
Click Confidential Print Setup.

Supporting IPSec

Internet Protocol Security (IPSec) provides authentication and encryption at the network layer allowing all application
and network connections over the IP protocol to be secure. IPSec can be set up between the printer and up to five
hosts, using both IPv4 and IPv6.
To configure IPSec using the Embedded Web Server:
1
Open a Web browser. In the address bar, type the IP address of the printer or print server to be protected using
the format: http://ip_address.
2
Click Configuration.
3
Under Other Settings, click Network/Ports.
4
Click IPSec.
IPSec supports two types of authentication:
• Shared Key Authentication—Authenticates any ASCII phrase shared among all participating host computers. This
is the easiest way to configure when only a few host computers on the network use IPSec.
•
Certificate Authentication—Authenticates any host computer or subnet of hosts for IPSec. Each host computer
must have a public/private key pair. Validate Peer Certificate is enabled by default, requiring each host to have a
signed authority certificate that is installed. Each host must have its identifier in the Subject Alternate Name field
of the signed certificate.
Note: After a printer is configured for IPSec with a host, IPSec is required for any IP communications to take place.

Supporting SNMPv3

Simple Network Management Protocol version 3 (SNMPv3) allows for encrypted and authenticated network
connections. It also lets a system support person select the desired level of security. Prior to use, at least one user name
and password must be assigned from the settings page.
To configure SNMPv3 through the Embedded Web Server:
1
Open a Web browser. In the address bar, type the IP address of the printer or print server to be protected using
the format: http://ip_address/.
2
Click Configuration.
3
Under Other Settings, click Network/Ports.
4
Click SNMP.
234