Rep 9.18 Air Pressure Tubes - Xerox 8825 Service Manual

REP 9.18 Air Pressure Tubes

Parts List on PL 9.9, PL 9.10
Switch off the Main Power Switch. Disconnect the Power Cord.
NOTE: The art used for this procedure was developed for previous products and may not
match the 8825/8830 configuration exactly.
Removal
1. Remove the Developer Module (REP
1
Remove the Grip
Ring
8825/8830 Printer
WARNING
9.5).
3
Remove the Air
Pressure Tube
2
Remove the gears (3)
Figure 1 Removing the Air Pressure Tubes
Do not rotate the Auger Gears individually more than the slight amount required for removal or
to mesh the teeth during reinstallation. If the factory setting of the augers is changed during the
procedure, perform the adjustment procedure, Augers
2. (Figure 1): Remove the Air Pressure Tubes.
3. Using a vacuum cleaner, remove the impacted Developer Material from the Housing
where the Air Pressure Tubes are attached. Pay special attention to the inside of the bot-
tom channel.
4
Remove the screw
01/02
4-79
CAUTION
(ADJ 9.6).
5
Remove the
retainer
6
Remove the Air
Pressure Tube
Repairs and Adjustments
REP 9.18