Print Defect Isolation Procedure; Workstation Checkout Procedure - Xerox 8825 Service Manual

Print Defect Isolation Procedure

Procedure
1. Go to Special Tests 0955 in Section 6 of this service manual. Select option 5 (600 mm
print length on 36 inch wide paper) and make an internal test print.
2. If the defect is still present, go to Print Quality Initialization Procedure
service manual.
3. Go to

Workstation Checkout Procedure

Service Call Procedures
Print Defect Isolation Procedure, Workstation Check-
in Section 3 of this
located in this Section.
Workstation Checkout Procedure
Initial Actions
1. Ensure that all connectors are seated correctly at the Controller.
2. If 8825/8830 DDS configuration, ensure that the SCSI cable from the Scanner is con-
nected to the scanner connector on the Controller.
3. The Configuration Test Print provides troubleshooting information that will be used later.
Ensure that the communication parameters are set correctly.
Procedure
NOTE: Do each of the steps in sequence, unless directed otherwise.
1. Ask the customer to print a different file from the workstation. If the file prints OK, then the
original file might be corrupt.
2. If the workstation is connected to a network, go to 3.. Otherwise, go to 5..
3. Ask the customer to obtain the IP address of another device on the network. Ask the cus-
tomer to go to the DOS prompt and to use the PING function to test the connection to the
other device. If the PING test is successful, then go to 4.. Otherwise, notify the customer
that there seems to be a network problem.
4. Obtain the IP address for the Controller from the Configuration Test Print. Ask the Cus-
tomer to use the PING function to test the connection to the Controller. if the test is suc-
cessful, then go to step 5. Otherwise, go to FRU (Field Replaceable Unit) Test in Section
2 of the Controller Service Manual.
5. Connect the laptop computer to the parallel port on the Controller. Open the Document
Submission Tool. Insert the test file disk in the laptop. Send a test file to the Printer. if the
defect is present, go to FRU (Field Replaceable Unit) Test in Section 2 of the Controller
Service Manual. Otherwise, ask the customer to reload the print drivers. If the problem
still exists, there could be a defective cable.
01/02
1-6 8825/8830 Printer