Maintenance Procedures - Xerox 8825 Service Manual

Table 1 Message Display Entry Chart
ALL ROLLS ARE Media Registration
EMPTY Sensor failed to
sense media.
NOTE: Substitute 1, 2, or 3 for X depending on which status code is displayed.
Service Call Procedures
Message Display Entry Chart, Maintenance Proce-
Go to C1-04.

Maintenance Procedures

INTER TASK
VAL
Nor- Check, clean, or Contaminated,
mal repair spacing worn spacing wheels or
Call wheels as drum ends cause print
required. quality defects.
Nor- Check and clean, if Contaminated grid, bent
mal required, the or contaminated
Call scorotron. Worn end blocks, are
also causes for scorotron
failure, which results in
print quality defects.
Nor- Clean the image Contamination
mal bar. print quality defects.
Call
As Repair or replace Contamination
Requir the scorotron/grid. print quality defects.
ed
Table 2 Xerographic Module
INTER TASK
VAL
01/02
1-12
Table 1 Image Module
REASON TASK ENABLER
dirty or Clean or replace spacing wheels and
the end surface that the wheels ride
on.
WARNING
pins.
The scorotron pin arrays are very
sharp. Use care when handling the
assembly.
If contaminated, remove scorotron
assembly and clean both sides of the
grid with a brush. Examine pins and
clean with brush Only if contami-
nated. Cleaning with a cloth can
deposit lint that will cause print qual-
ity problems.
causes Clean the image bar with a lint free
cloth and lens cleaner.
causes WARNING
The scorotron pin arrays are very
sharp. Use care when handling the
assembly.
Replace the grid and/or pin array.
Perform ADJ 9.2 Electrostatic
Series.
REASON TASK ENABLER
8825/8830 Printer