Rep 9.1 Xerographic Module - Xerox 8825 Service Manual

REP 9.1 Xerographic Module

Parts List on PL 9.1, PL 10.1
Switch off the Main Power Switch. Disconnect the Power Cord.
Removal
1. Loosen the screws and open the Rear Door.
2. Raise and latch the Top Cover.
3. Lift and rotate the Image Module to the Service Position.
4. Lower the Media Transport Cover.
NOTE: Figure 1 shows only the Front Support Bracket.
5. (Figure 1): Prepare the Front and Rear Support Brackets for raising the Xerographic Mod-
ule to the Service Position.
8825/8830 Printer
WARNING
1
Lift the bracket at the
tab in order to discon-
nect the spring
Figure 1 Preparing the Support Bracket
6. Remove the Web Oiler Assembly
01/02
4-43
2
3
Pull the spring away
Push the bracket down
from the shaft
to the horizontal posi-
tion
Tab
4
Disconnect A23P1
5
Perform Steps 1
through 3 for the Rear
Support Bracket
(REP 10.7).
Repairs and Adjustments
REP 9.1