Rep 8.5 Pressure Plates - Xerox 8825 Service Manual

REP 8.5 Pressure Plates

Parts List on PL 10.3
Switch off the Main Power Switch. Disconnect the Power Cord.
NOTE: The art used for this procedure was developed for previous products and may not
match the 8825/8830 configuration exactly.
Removal
1. Latch the Xerographic Module at the Service Position
2. Remove the Media Transport Assembly
3. Remove the Fabric Guide (REP 8.9).
Be sure to push the Buckle Switch Actuator down while starting to remove the Upper Pressure
Plate in order to prevent damage to the actuator.
4. (Figure 1): Remove the Upper and Lower Pressure Plates.
Repairs and Adjustments
REP 8.5
WARNING
(REP 9.2).
(REP 8.1).
CAUTION
1
Push the Buckle
Switch Actuator
down (not shown)
2
Remove the Upper
Pressure Plate
Figure 1 Removing the Pressure PLates
01/02
4-26
3
Remove the Lower
Pressure Plate
8825/8830 Printer