Xerox 8825 Service Manual page 292

1
Insert the locking tab on the ter-
minal over the hook on the
Extractor Tool
Figure 4 Removing the Locking Tab
5. Reinstall the terminal to the pin position from which it was removed.
6. Reinstall the individual module connectors to the correct locations noted at the beginning
of this procedure. Refer to Section 7 for detail of connector configuration.
General Procedures
Molex Connector Repair Procedure
2
Rotate the terminal until it is par-
allel with the line on the tool
01/02
6-52 8825/8830 Printer