Adj 8.3 Cut Length - Xerox 8825 Service Manual

ADJ 8.3 Cut Length

Purpose
The purpose is to calibrate the Printer to produce the correct length prints for each media type.
Prerequisite
1. Check the following:
a. Fuser Temperature (NVM) ( ADJ
b. Vertical Magnification ( ADJ 8.1)
c. Lead Edge Registration ( ADJ
Adjustment
1. Enter diagnostics.
2. Enter code [ 0955] and make one 600 mm print and one 1200 mm print of Test Pattern #7.
3. Allow the prints to cool for five minutes.
4. ( Figure 1): Measure the two prints in the paper feed direction.
Figure 1 Checking the Print Length
5. Enter code [ 0700] in order to adjust the Cut Length. Enter [ 1] to adjust.
6. ( Figure 2): Select the type of media. The following message is displayed. (In this exam-
ple, bond paper media has been selected.)
Repairs and Adjustments
ADJ 8.3
10.1)
8.2)
7. ( Figure 3): Enter the measurement of the 600 mm print and press the Enter button. The
following message is displayed.
8. ( Figure 4): Enter the measurement of the 1200 mm print and press the Enter button.
The following message is displayed.
Figure 4 Print Measurement
9. Complete the adjustment as appropriate.
10. Repeat the check for all the types of media used by the customer.
01/02
4-100
Figure 2 Media Select
Figure 3 Print Length
8825/8830 Printer