Xerox 8825 Service Manual page 158

1. (Figure 4): Reinstall the Heat Rod.
NOTE: Do not remove the connectors from the wires on the ends of the Heat Rod.
a. Insert the red connector into the Heat Roll.
b. While looking into the roll, push the red connector through the hole in the Fuser
Drive Gear at the opposite end.
c. If the previous step is too difficult, use the rod that secures the Fabric Guide as a
tool. Insert that rod through the right side of the Heat Roll, secure the red connector
to it, and pull the Heat Rod through the Heat Roll.
Repairs and Adjustments
REP 10.1
1
Straighten the wire at the
red connector end (as
straight as possible)
2
Reinstall the
Heat Rod
Figure 4 Reinstalling the Heat Rod
01/02
4-90
3
Insert the con-
nector into the
Hub Assembly
4
Reinstall the hub
Assembly with the
flat sides positioned
as shown
8825/8830 Printer