Rep 7.7 Motion Sensor - Xerox 8825 Service Manual

REP 7.7 Motion Sensor

Parts List on PL 7.2
Switch off the Main Power Switch. Disconnect the Power Cord.
Removal
1. Loosen the screws and open the Rear Door.
2. Remove the Rewind Clutch (REP 7.6).
3. (Figure 1): Remove the Motion Sensor.
5
Press the Motion
Sensor tabs outward
through the slots
1
Disconnect the
connector
Figure 1 Removing the Motion Sensor
Repairs and Adjustments
REP 7.7
WARNING
6
Remove the
Motion Sensor
4
Remove the
Rewind Housing
3
Remove the
screws (3)
2
Remove the Encoder
Disk
Replacement
1. Reinstall the Motion Sensor and the Rewind Housing.
2. (Figure 2): Reinstall the Encoder Disk.
Figure 2 Reinstalling the Encoder Disk
01/02
4-14
3
Ensue that the slot in the
encoder Disk aligns with
the pin in the shaft
2
Reinstall the Encoder Disk
1
Align the open slot in
the Encoder Disk with
the opening the housing
8825/8830 Printer