Xerox 8825 Service Manual page 116

7. (Figure 3): Move the bearing out of the Xerographic Module Frame (Left Side).
2
Lift the Drum Assembly and
move the bearing to the right
1
Disconnect the retain-
ing clip that holds the
bearing and rotate the
clip out of the way
Figure 3 Moving the Bearing (Left Side)
Repairs and Adjustments
REP 9.2
Drum Assembly
3
Carefully lower the
Drum Assembly
01/02
4-48
8. (Figure 4): Move the bearing out of the Xerographic Module Frame (Right Side).
3
Holding the gearbox out of the grommet, move the
Drum Assembly
Drum Assembly to the right while moving the bearing
out of the frame (Without Tag 8)
Figure 4 Moving the Bearing (Right Side)
2
Discon-
nect P/J 2
1
Loosen the wingnut and
rotate the gearbox to
disengage the bracket
from the grommet
8825/8830 Printer