Rep 3.1 Main Pwb - Xerox 8825 Service Manual

REP 3.1 Main PWB

Parts List on PL 1.1A
Switch off the Controller and the Printer Main Power Switches. Disconnect the Printer
Power Cord.
Electrostatic Discharge Damage (ESD) may occur. Use ESD procedures and Antistatic Wrist
Strap to avoid damage to PWBs or components.
Removal
1. Check the Printer Tag Matrix to see if Tag 28 is installed. This information will be needed
later in this procedure.
2. (Figure 1): Prepare to remove the Controller.
8825/8830 Printer
WARNING
CAUTION
3
Lift out the
Controller
and set it on
the floor.
Figure 1 Removing the Controller
3. Attach a Static Wrist Strap between your wrist and the unpainted metal chassis of the
Controller.
01/02
4-3
1
Remove 2 screws
from the Printer
Right Lower Cover,
and tilt the cover
back slightly.
A3 p307B
A1P3
2
Disconnect con-
nectors A3P
307B and A1P3.
Repairs and Adjustments
REP 3.1