1
Loosen screw
4
Repeat steps 1 through 3
on other side
Figure 2 Engaging the Shipping Brackets
17. (
Figure
3): Install the shipping pads.
General Procedures
Removal Procedure
2
Slide bracket onto the shaft
3
Retighten screw
18. Remove the Charge Scorotron Assembly (
19. (
01/02
6-44
Image Module at Service Position
Figure 3 Installing the Shipping Pads
and place it in a Media Supply Drawer.
Figure
4): Open the Media Transport Cover and secure the Stripper Finger Assembly
with a cable tie.
1
Install the shipping pads, one on
each end of photoreceptor
2
Install the
foam pads,
one on each
side
REP
9.8), wrap the assembly in bubble pack,
8825/8830 Printer