Replacing Or Adding A Processor - Gateway E-9425R User Manual

10
11

Replacing or adding a processor

replacing a processor or heat sink, allow them to cool for several minutes.
heatsink could damage the processor.
The server is compatible with as many as two Intel® Xeon DP (Dual Core) 5100 Series processors.
The server automatically detects the processors each time you turn it on. Whenever you install
new processors, you should first install the most current version of the BIOS. For instructions,
see
If you are upgrading your server from one processor to two, you may need to reconfigure
your operating system so it can recognize the additional processor. For instructions, see
your operating system's documentation.
If you install two processors onto the system board, the processors must be the same
speed, revision, core voltage, and bus speed.
To replace a processor:
1
2
3
www.gateway.com
Important
Make sure that the arrows on top of the fans indicating airflow point to the
back of the chassis. The fan cable should exit the fan module toward the back of
the chassis.
Connect the 6-pin fan tach cables from the fans to the fan tach connectors on the fan board.
Follow the instructions in
Warning
Processors and heat sinks may be hot if the computer has been running. Before
Caution
A heat sink must be installed on the processor. Installing a processor without a
"Updating the BIOS" on page
Important
You must have a processor in the Processor 1 socket, or your server will not start.
Install the most current BIOS version. For instructions, see
Follow the instructions in
that you turn off the server, then unplug the power cord(s) and all other cables connected
to the server.
Follow the instructions in
"Closing the server case" on page
58.
"Preventing static electricity discharge" on page
"Opening the server case" on page
30.
"Updating the BIOS" on page
28. Make sure
29.
58.
43