Table of Contents
Advertisement
Aileron Servo Installation
1.
The ailerons have been pre-hinged and glued
to the wing panels and are ready for flight. No
other steps are necessary for hinging. Clear
Ultra Cote is supplied for sealing the hinge
gaps if desired. However, due to the precisely
aligned and minimal hinge gap this step is op-
tional. Gather one wing panel, two aileron ser-
vos, 1 Y harness, and 1 18" servo extension as
shown below for servo installation.
2. Layout the servos, extensions and Y harness on
the wing to test fit the installation and ensure
servo leads are the correct size.
Recommended servo:
160 in. oz. / Metal geared / Digital
WING ASSEMBLY
3.
4.
9
Attach the 18" extension to the outboard servo
lead and secure with safety wire, string, tape,
or other method. Ensure the connectors will
not come apart from vibration or light tension.
Fasten the pull string from the outboard servo
hole to the male connector of the servo exten-
sion. Secure with tape so that the string pulls
from the front end of the connector
in drawing the servo wire through the
wing without hanging up inside the wing.
to assist
Hide quick links:
Advertisement
Table of Contents
