Table of Contents
Advertisement
7.
Shown below is an alternative way to make
the throttle and choke servo push rod.
This method does not require any soldering.
However, does require an additional Ball link
and 4-40 All thread
(Not supplied)
8.
Typical 4-40 All thread pushrod shown below
9.
Typical servo installation for rear carburetor
engine. The exact servo installation will de-
pend on the engine used. Align the servo tray
so there is no binding on the pushrods.
Fuel Tank Assembly
1.
Gather the fuel tank parts as shown below.
Fuel tank parts, fuel tubing, and foam rubber.
Note: The fuel tank supplied with your kit
may differ slightly from the tank pictured be-
low.
79
Hide quick links:
Advertisement
Table of Contents
