Table of Contents
Advertisement
11.
Attach the rudder servo coupler assembly to
the rudder servos as shown. Do not tighten the
easy link set screws until the rudder servos are
powered up and centered.
12. Optional ball link rudder servo coupler assembly
is shown below. Use 4-40 all thread with cop-
per, brass, or carbon tubes over the all thread rod
to give adequate strength.
Note: Rudder coupler hardware is not supplied
13.
Plug the rudder servo Y harness into the rud-
der channel of the receiver and power up.
Turn on transmitter to center rudder servos.
Tighten easy link set screws or adjust optional
ball links so that servos do not fight each other
at center or at either end point.
14.
Tape the rudder balance tab to the top leading
edge of the vertical fin in the neutral position
as shown. This ensures the rudder is straight
when the cables are attached.
27
Hide quick links:
Advertisement
Table of Contents
