13.
Recheck for proper clearance. Make sure the
firewall does not contact the engine carburetor
mount.
14. Mount the engine using the engine manufacturer
recommended bolts (not supplied) and lock-tite.
Use the provided aluminum spacers to make the
front of the engine prop hub (back of spinner)
7 to 7 1/4 inches
from the firewall as shown.
15.
Securely tighten the engine to the firewall as
shown. We recommend using 1/4-20 bolts
and lock nuts for engine mounting. You may
also use blind nuts behind the firewall for en-
gine mounting.
Note: The use of large fender washers is rec-
ommended between the spacers and firewall to
distribute loads.
16.
Typical rear carburetor engine installation be-
fore re-installing the carburetor.
43