Table of Contents
Advertisement
7.
It is recommended to center punch the location
of the engine mounting holes prior to drilling.
8.
Use a 1/4 drill to drill the engine mounting
holes.
9.
Remove the engine back plate mounting
screws and re-install using locktite.
10.
Use the provided spacers to make the front of
the engine prop hub (back of spinner)
7 to 7 1/4 inches from the firewall as shown.
Note: The use of large fender washers is rec-
ommended between the spacers and firewall to
distribute loads.
47
Hide quick links:
Advertisement
Table of Contents
