Table of Contents
Advertisement
9.
Place the flat washers inside the counter sunk
holes as shown. Ensure the washer is fully
seated inside the counter sunk holes.
10.
Use a small piece of medium sand paper to
scuff one side of the silicon rubber to ensure a
good glue bond.
11.
Apply thick CA glue to the scuffed side of the
silicon rubber piece.
12.
Glue the silicon rubber piece on top of the
counter sunk holes on the plywood canister
mounting bracket. This will seal the washers
inside the canister bracket mount as shown.
57
Hide quick links:
Advertisement
Table of Contents
