Wing Assembly - AeroWorks Carbon Cub SS ARF-QB Assembly Manual

Aileron/Flap Servo Installation
1. The ailerons/flaps have been pre-hinged and
glued to the wing panels and are ready for
flight.
Required Parts
◊
1 - Wing panel
Required Parts -Not Included
◊
1 - Aileron servo
◊
1 - Flap Servo
◊
8 - Servo Mounting Screws (Micro Fastener
Part number STW0209 recommended)
◊
2 - 1 1/2" servo arms
◊
2 - Safety clips
◊
1 - 48" Servo Extension
◊
1 - 6" Servo Extension
Required Tools and Adhesives
◊
1 - 5/64" Ball Driver
◊
1 - 3/32" Ball Driver
◊
1 - Pushrod Adjustment Wrench (Supplied)
◊
1 - Electric Drill
◊
1 - 1/16" Drill Bit

WING ASSEMBLY

2. Layout the servos as shown below. Install the
extensions at this time and double check exten-
sion length.
3. Attach the 48" extension to the aileron servo
lead and secure with Aeroworks Safety Clip.
Ensure the connectors will not come apart from
vibration or light tension. Safety clips available
from Aeroworks.
4. Fasten the pull string from the servo hole to the
male plug of the servo extension.
18