Table of Contents
Advertisement
13.
Remove servo and use a 1/16 bit to drill servo
mounting holes.
14.
Install servo with servo mounting screws.
15.
Repeat mounting steps for other servo so that
both aileron servos are mounted in bottom of
wing as shown.
Aileron Control Linkage Installation
1. To locate the control horn, use a ruler against the
outboard side of the servo case to project a line
to the leading edge of the aileron and mark as
shown.
Note: The control horn mounting holes may have
been factory drilled for you. If so, go to the
next step.
12
Hide quick links:
Advertisement
Table of Contents
