Wing Assembly - AeroWorks EXTRA 260 ARF-QB Assembly Manual

Aileron Servo Installation
1. The ailerons have been pre-hinged and glued to
the wing panels and are ready for flight. No
other steps are necessary for hinging. Clear
Covering is supplied for sealing the hinge gaps if
desired. However, due to the precisely aligned
and minimal hinge gap this step is optional.
Gather one wing panel, three aileron servos, two
11" Y harnesses, one 24" and one 36" servo
extension as shown below to begin the servo
installation.
Note: 6" extension will also be needed per wing
when connecting aileron servos to receiver.
2. Layout the servos, extensions and Y harness on
the wing to test fit the installation and ensure
servo leads are the correct length.
Minimum recommended servo:
180 in. oz. / Metal geared / Digital

WING ASSEMBLY

3.
4.
14
Attach the 36" extension to the outboard servo
lead and secure with safety wire, string, tape,
or other method. Ensure the connectors will
not come apart from vibration or light tension.
Remove the balsa stick with the pull string
from the outboard servo well as shown.