Table of Contents
Advertisement
23.
A drop of thin CA may be applied to the
swage tube to help secure the cable
24.
Hold the threaded coupler below the cable at-
tach holes to thread into the ball link as shown.
Do not hold coupler at the top where the cable
hole is located. This may cause burrs on the
coupler that can eventually cut the rudder pull
cable.
25.
Attach ball links to rudder control horns on
both sides with 4-40 socket head bolts and ny-
lon safety nuts as shown.
26.
Adjust rudder pull-pull cables to desired ten-
sion by screwing in or out on the threaded cou-
plers and or ball links. Make all adjustments
with the rudder servos still powered up and
centered, and the rudder still taped in the neu-
tral position. Ensure the servos do not fight
each other at center or at either end point.
30
Hide quick links:
Advertisement
Table of Contents
