Table of Contents
Advertisement
11.
Use a small piece of medium sand paper to
scuff one side of the silicon rubber to ensure a
good glue bond.
12.
Apply thick CA glue to the scuffed side of the
silicon rubber piece.
13.
Glue the silicon rubber piece on top of the
counter sunk holes on the plywood pipe
mounting bracket. This will seal the washers
inside the pipe bracket mount as shown.
14.
After the CA glue has fully cured, use a hobby
knife to cut two small round holes in the sili-
con rubber. The holes should be just large
enough to allow the heads of the pipe mount-
ing bolts to pass through the silicon rubber and
seat against the washers inside.
67
Hide quick links:
Advertisement
Table of Contents
