Table of Contents
Advertisement
13.
After the CA glue has fully cured, use a hobby
knife to cut two small round holes in the sili-
con rubber. The holes should be just large
enough to allow the heads of the canister
mounting bolts to pass through the silicon rub-
ber and seat against the washers inside.
14.
Insert the canister mounting bolts through the
holes in the canister mounting bracket as
shown.
15.
Locate the nylon tie canister mounting strap
and the silicon rubber tubing as shown below
16.
Use a pair of scissors to split one end of the
silicon tubing in half approximately 3/4" deep
as shown.
58
Hide quick links:
Advertisement
Table of Contents
