Table of Contents
Advertisement
15. To allow easier threading, remove ball links
from the rudder control horns. Attach two
threaded couplers to ball links as shown.
Thread ball link half way onto threaded coupler
16.
Hold the threaded coupler below the cable at-
tach holes to thread into the ball link as shown.
Do not hold coupler at the top where the cable
hole is located. This may cause burrs on the
coupler that can eventually cut the rudder pull
cable.
17.
Attach ball link to rudder control horn on both
sides of the rudder. Thread the rudder cable
through a brass swage tube, then the threaded
coupler, and back through the brass swage
tube on both sides. Pull light tension on the
cable through the coupler on both sides as
shown. The loop through the coupler should
be approximately 1/2" long.
18.
Loop the cable back through the brass swage
tube as shown.
28
Hide quick links:
Advertisement
Table of Contents
