Table of Contents
Advertisement
4. Center the rudder control horn over the mark and
mark the locations of the control horn mounting
holes.
Note: The control horn mounting holes may have
been factory drilled for you. If so, go to the next
step.
5. Use a 1/16 bit to drill control horn mounting
holes.
Note: The control horn mounting holes may have
been factory drilled for you. If so, go to the
next step.
6. Align the left and right sides of the control horns
to the mounting holes and mount using six wood
screws as shown.
Note: Use thin CA to lock screws in place
7.
Repeat the above steps for mounting the other
side rudder control horn.
Rudder Servos Installation
1. Gather the two rudder servos and a Y harness as
shown below.
Note: If using a higher Torque (300oz min.) Digital,
Metal geared servo, only one servo is required.
22
Hide quick links:
Advertisement
Table of Contents
