Wing Assembly - AeroWorks ProX260 ARF-QB Assembly Manual

Aileron/Servo Installation
The ailerons and wings come pre-hinged but are
not glued. The builder must glue the hinges in
place using thin CA.
1. Center the hinge in the pre-cut hinge slot us-
ing T-pins. Make sure that the hinge is
straight to prevent binding.
2. After all 5 CA hinges have been placed in the
wing slide the aileron onto the hinges. Once
again it is very important that the hinge stay
straight.

WING ASSEMBLY

3. Use a straight edge to make sure that the aileron
sits flush with the wing-tip.
4. Remove the T-pins from each hinge. Using a
new bottle of thin CA apply 3-4 drops on each
side of the hinge. Be careful not to over soak the
hinges with CA this can cause failure.
Note: Always use a fresh bottle of CA. Old CA will
13
not cure and can cause failure.