Table of Contents
Advertisement
6.
Push the wires under the rudder servo tray and
install the forward servo.
7. Mark and use a 1/16 bit to drill the rudder servo
mounting holes.
Note: If using a higher Torque (300oz min.) Digital,
Metal geared servo, only one servo is required.
8.
Install rudder servos with servo screws.
Rudder Pull-Pull Cable Installation
1.
Gather the rudder control linkage parts shown
below. 2 Rudder cables, 2 threaded metal RC
links, 4 threaded couplers, and 4 brass swag-
ing tubes.
24
Hide quick links:
Advertisement
Table of Contents
