Fuel Tank Assembly And Installation - AeroWorks Carbon Cub SS ARF-QB Assembly Manual

FUEL TANK ASSEMBLY AND INSTALLATION

Fuel Tank Assembly
1. Gather the fuel tank parts as shown below.
Required Parts
◊
1 - 750cc Smoke Tank
◊
1 - 1000cc Gas Tank
◊
2 - Rubber Stoppers
◊
6 - Brass Tubes
◊
2 - Aluminum Stopper Front Plates
◊
2 - Aluminum Stopper Back Plates
◊
2 - Phillips head bolts
◊
4 - Brass Barbs for Fuel Line
Required Parts -Not Included
◊
1 - Aeroworks Fuel Line Installation Kit
Required Tools and Adhesives
◊
1 - Pencil/felt tip pen
◊
1 - Phillips Screw Driver
◊
1 - Wire Cutter
◊
1 - Soldering Iron
◊
1 - Silver Solder "Sta-Brite Recommended"
◊
1 - 80 Grit Sandpaper
2. Locate the (2) supplied brass fuel barbs. Solder a
brass fuel barb to the fuel line pick up tube. This
will keep the weight of the fuel clunk from pull-
ing the fuel line off the brass tube.
Note: No brass barbs are required for the air vent
lines.
3. Assemble the fuel pick up line, rubber stopper
and metal end caps. As shown below.
4. Solder a brass fuel barb to the other end of the
fuel pick up line.
65